![]() ![]() The common method of illumination for these artificial Christmas trees was a floor-based "color wheel" which was placed under the tree. Types of tree stands Ĭhristmas tree stands sometimes had a more specialized role when it came to aluminum Christmas trees. Another example of a homemade-type Christmas tree stand is a converted cast iron garden urn. Not all Christmas tree stands are manufactured for the specific purpose, one example would be a makeshift Christmas tree stand made from an old two-gallon (~7.5 l) bucket or can. Washington State University plant pathologist Gary Chastagner conducted research into various models of Christmas tree stands and found that just six of 22 different stands tested had adequate water capacity for Christmas trees larger than 4 inches (10 cm) in diameter. In fact, growers state that the secret to long-lived natural Christmas tree is a lot of water, so often they recommend a tree stand that has a large water reservoir. Design Ĭhristmas tree stands designed for natural Christmas trees often have a water-well in them natural trees require water so that they do not dry out. Once the tree trunk was inserted into the water inlet, the tree would be kept fresh and green much longer than without the water supply. Water placed in the galvanized iron shell would give considerable weight to the stand to steady the tree. ![]() The stand featured a broad, cone-shaped base that included an inlet for water and the Christmas tree trunk. In 1919, an American monthly magazine Popular Science touted a new type of Christmas-tree stand. In the center of this Is a hole into which to fasten the tree. I then painted the fence white, and the board grass-green. The best tacks I could find for tacking the palings to the cross-pieces were pins cut in two, using only the head ends. The palings are about 1/8-inch thick, and 1/2 inch wide, and the cross pieces are just a little thicker. 1919 bottle-shaped Christmas-tree stand configured to be weighted by water or sand to support the tree.Īs Christmas is near at hand, I will tell how I made a pretty stand for a Christmas tree: I took a board 14x14 inches, and one inch thick around this I made a tiny paling fence - there is a post at each corner set firmly Into a 1/4-inch hole, and a gate at the middle of one side with little posts, the same as at the corner. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |